Stop compromising rod holder standards by forcing a decision between holding a bait caster, spinning reel, offshore reel, or fly reel. The Rod Holder II will hold any type of rod and reel, with quick adjustments. The rotating collar helps reduce 'strike-theft' and the rear gimble lock reduces rod rotation for compatible rods. This rod holder is fully adjustable 360 degrees around and over 90 degrees vertically. Like all RAILBLAZA accessories, this the Rod Holder II fits all RAILBLAZA bases. No hardware is needed for accessory installation because the RAILBLAZA port based system is not included. **All RAILBLAZA accessories fit the different RAILBLAZA port based systems. Base not included.
The G-Hold 50 is recommended to secure paddles, boga grips and anything of moderate size up to 2 inches around. This G-Hold is 50mm(2 inches). The flexible quick-release strap has two securing points for security of minimum and maximum diameters, providing strong retention. The G-Hold strap has rungs with which to set the tension of each G-Hold firmly. While G-Holds are supplied in singles, it is recommended to use two for long-spanning objects, similar to molded rubber or folding paddle clips. During installation, make sure the G-Holds are parallel when mounted in pairs. When fitting to a StarPort on a vertical surface, make sure the longer arm is positioned at the bottom because this provides extra support before tensioning the strap in place. All G-Holds install in any RAILBLAZA base. No hardware is needed for accessory installation because the RAILBLAZA port based system is not included. **All RAILBLAZA accessories fit the different RAILBLAZA port based systems. Base not included.